Warranty
LIMITED WARRANTY
Diaz Manufacturing Company LLC warrants its’ products for one year from the shipment date. If a
defective item cannot be replaced, we will refund the amount charged for the item. All warranties
are limited to the item’s original cost.
All wood products are affected by their environment throughout the useful life of the product. Even
after finishing, doors and drawer fronts must be protected from high and low temperatures and
humidity. Our lumber is kiln dried to the moisture content considered to be in balance with the
relative humidity of the average air conditioned home - approximately 35%. Very dry conditions will
shrink panels and joints, high humidity will cause panels and frames to expand. Diaz Manufacturing
Company LLC will only warranty products that are installed in
climate controlled conditions.
Doors up to 26” wide and 48” high are warranted against warping not to exceed 1/8”.
Panel and frame doors over 48” high will be made two panels high and will carry a warranty against
warping of more than ¼”.
Panel and frame doors over 26” wide will be made two panels wide and will carry a warranty against
warping of more than ¼”.
Doors over 84” high or wide will carry a warranty against warping of more than ½”.
Solid drawer fronts up to 44” wide and 22” high are warranted against warping that exceeds 1/8”.
Because their design does not accommodate the natural expansion and contraction of wood,
DPB, DVB, DRV and DCS doors cannot be warranted against warping or panel movement.
Mitered doors will allow .030” of joint gap 1” from inside bead.
Mitered doors cannot be warranted for joint separations that result from exposure to
areas of high humidity or areas of high moisture content.
Due to potential movement that may occur in a miter joint as a result of a variety of
external factors, Diaz Mfg. does not recommend painting or using opaque finishes on
miter design products and will not warranty these items.